Dicas Reparação





Pesquisa:

Resultados 81877

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyXS8031PART NUMBER CORRECTION: SPEAKER (CORRECT # IS 1-544-126-11) The part number shown in the service manual for the speaker isincorrect.
SonyXRU800NO RESPONSE TO KEYS ON FACEPLATE The unit would not respond when any of the keys on thefaceplate were pressed (however, the tape control keys would work after atape was loaded).
SonyXRU700ERRATIC TAPE DECK OPERATION (FOUND ROTARY S902 DEFECTIVE) Tape loads in steps then ejects. Very erratic movement oftape transport.
SonyXR6450UNIT LOADS/UNLOADS TAPE AT RANDOM (CLEANED MODE SWITCH S901) The unit would load/unload tape at random.
SonyXR6450NO AUDIO (FOUND IC601 DEFECTIVE, LANDS DAMAGED) Unit had no audio. Found pins 6 and 7 of IC601 were notsoldered, or became unsoldered when IC601 failed. Also, several landswere damaged.
SonyXR6450INTERMITTENT AUDIO FROM LINE OUT, SPEAKER OUT OK The unit had intermittent audio from the line out connector.The speaker out was OK.
SonyXR6450JAMMED MECHANISM (CAUSED BY DAMAGED GEAR ON REF. 128) The mechansim was jammed.
SonyXR6450NO AUDIO (FOUND Q311 DEFECTIVE) The unit had no audio.
SonyXR6450NO DISPLAY, ALL OTHER FUNCTIONS OK (FOUND D571 DEFECTIVE) The unit had no display. All other functions were normal.
SonyXR6450EATS TAPES (FOUND B-T WASHER REF. 124 WAS MISSING) The unit eats tapes.
SonyXR6450CAPSTAN MOTOR RUNS CONSTANTLY (FOUND Q403 DEFECTIVE) The capstan motor in the tape mechanism runs constantly.
SonyXR6450POP NOISE WHEN UNIT TURNED ON (FOUND Q230 DEFECTIVE) There was a pop noise heard from the speakers when the unitwas turned on.
SonyXR6450NO AUDIO (FOUND ELECTRONIC VOLUME CONTROL IC301 DEFECTIVE) The unit had no audio.
SonyXR6450TAPE AUDIO POOR; NO AMS (FOUND DEBRIS IN TAPE HOLDER) The tape audio was poor, and the AMS feature did not work.
SonyXR6450DEAD (FOUND OPEN TRACE FROM CN900 PIN 2) Dead.



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads