| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDFX435 | DEAD UNIT/X301 VS110 BD | Unit dead except for Ever 5v. Mode cpu/IC503 dead in water. Caused by defective X501/32khx clock which must run for the cpu to wake upand activate the master clocek. Replacement resolved problem. | ||
| Sony | CCDFX420 | BW PIX IN REC EVERYTHING ELSE OK/C019-CS37 BD | CN505 pin 11 to C019 the other side goes to pin 2 of Ic001RFC line. Fouind C019 missing. | ||
| Sony | GDM20SE1 | H PIN/KEY BAL, CENTERING, AND D FOCUS OFF | Unable to adjust Horiz. Pincushion and Keystone Balance.Horiz. Centering and Dynamic Focus were wrong. | ||
| Sony | GDM20SE1 | PICTURE OFFSET RIGHT 2 INCHES | Picture was moved to right 2 inches in all modes. NormalVGA mode had enough range to set back to center, but Mode 5 and above didnot have enough range. | ||
| Sony | CPD1425 | H. POSITION CONTROL VR DEFECTIVE | Picture shifts horizontally. | ||
| Sony | CDU33A | NO AUDIO WINDOWS 95 | Customer had no audio. Audio line from Headphone Jack wasOK. Video data to computer was OK. | ||
| Sony | WMFX415 | NO AUDIO FROM TAPE (RADIO O.K.) - REPLACE HEAD CABLE | Either no audio from tape, or audio only from one channel. | ||
| Sony | WMFS495 | DEFECTIVE HEADPHONES | Headphone ear piece broken. May have been shipping damage orjust hard use. | ||
| Sony | MZR2 | DISTORTED LINE INPUT | Record input distorted in left channel, line in only. Foundsignal looked ok at both input to IC303 but DC level at pin 3 too low, .6vshould be 2.2v. | ||
| Sony | MZR2 | LINE OUT, AUDIO | Unit had no line out. -SOLUTION :LF304 filter open, replaced. | ||
| Sony | CFS1035 | NO AUDIO IN TAPE MODE (RADIO O.K.) | In tape mode: Either no output or output on only one channel. | ||
| Sony | SLVR5UC | NO TUNER VIDEO, NO PB COLOR - REPLACE IC653 | No tuner video, audio ok. No color on pB. Video signal onpin 2 IC653 ok. No output on pin 4. | ||
| Sony | SLVR1000 | HOW DO WE ADJUST CLOCK? BOARD AVAILABLE AT TECH DEPT (KHALED | The service manual shows an IC used to adjust clock. On other units (SLVR5) this was available as a PC board. The CKT is slightly different for the SLVR1000 and will there be a board made available for this model? With | ||
| Sony | SLV940HF | DAMAGED LOADING ASSEMBLY - REPLACE FL ASSY | Wouldn't accept tapes loading assy was bent. | ||
| Sony | SLV940HF | NOISY UNIT - REPLACE GND SHAFT ASSY WITH NEW IMPROVED | Noise in play and record. Noise caused by drum assy. Unit returned by customer to Good Guys. |