Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | XMF10 | FERRARI OEM MODEL, REPAIR AT DETROIT OEM ONLY | |||
Sony | CDXF10 | FERRARI OEM MODEL, REPAIR AT DETROIT OEM ONLY | |||
Sony | CDX5070 | WOULD NOT ACCEPT DISCS (FOUND Q1 DEFECTIVE) | At power-up, loading motor would run for several seconds, evenwith no disc inserted. When I did insert a disc, the player would notaccept it. I checked action of disc detection photosensor signals PH1 andPH2. PH1 was always high. PH2 toggled normally wh | ||
Sony | CCDV8AFU | CAPSTAN MOTOR WILL NOT START IN REVERSE DIRECTION / RPL C414 | The capstan motor will not go in reverse mode. Found highlevel ripple on audio 5 v lines caused by shorted C414. Apparently shouldnot cause capstan propblems. | ||
Sony | CCDTR71 | INTERMITTENT PLAYBACK VIDEO - C303/VS-93 BD | Unit came in with e-e ok but there was no playback video signal.I followed video up through Ic151. At Ic151 pin#7 signal was good but atpin#3 signal was lost. I then followed signal through some transistors upto Q166 and the signal was still good | ||
Sony | CCDTR71 | ROLLING BLACK DATA SCREEN IN VIEWFINDER L852/VC112 BD | In camera mode there would be a rolling black datascreen in the viewfinder and no video out. No sync burst or video. | ||
Sony | CCDTR70 | WHEN VC-145 BOARD REPLACED IMAGER DOESN'T WORK/REVERSE CN701 | Imager stops working after board is replaced. | ||
Sony | CCDTR70 | NO CHROMA CAMERA E TO E - L605/VC BOARD | No chroma camera video Found that L605 was not passing the chroma signal. | ||
Sony | CCDTR70 | NO EVF PIX / MISSING DATA PAGE "D", ADDRESS B0 TO BB | No EVF pix. | ||
Sony | CCDTR61 | NO POWER C923/DD-56 BD | unit came in with no power. i checked the fuses and f902 wasblown. after replacing the fuse and powering it back up it blew anotherfuse. i measured this line to ground which measured a short. i thendisconnected the power supply and then powered up the | ||
Sony | CCDTR5 | NO ZOOM (TELE OR WIDE)- Q703/LD-11 | unit came in with no zoom in both directions. there was nooutput to the zoom motor. going back to the zoom motor drive i found theinput ok but no output. taking dc measurements around this ic i foundpin#5 of ic701 low. following this back through | ||
Sony | CCDTR5 | NO SYNC AND LOW LUMINANCE IN PLAYBACK - C270/VS-22 BD | Unit came in with low or no luminance and no sync (In playback).Following Y signal up to ic203 pin#30 signal was bad. I then back-trackedto pin#31 which the signal was good there. Then going to q216 signal wasgood at both base and emitter. Going eve | ||
Sony | CCDTR400 | NO VIDEO FROM IO JACKS / CAB. KNOCKING PARTS OFF BOARD VS104 | No video from IO Jacko on camcorder. | ||
Sony | CCDTR30 | NO OUTPUT VIDEO - IC151/VS BOARD | Video was in viewfinder but not outputting to cables however audio was good to outputs solution: No output from pin 38 ic151 on vs bd all inputs were correct the ic was bad | ||
Sony | CCDTR101 | DEAD - X922/VC103 BD |