| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCD-FX430 | UNIT IS DEAD / RESOLDER CN203 | Unit is dead. I've seen this on units of this type. | ||
| Sony | ACV25 | WON'T CHARGE BATTERY / OPEN GND CONNECTION | No charge light or charging with battery load put onterminals, but charge light and voltage came on when negative tereminalswitch is triggered with no load. | ||
| Sony | ACS10 | UNIT DOESN'T CHARGE / SEPARATED TERMINAL BD | Unit would not charge, inst refresh light would stay on. | ||
| Sony | ACS10 | NO CHARGE OF BATTERY - RESOLDER S501/TB1 BD | Will not charge battery all B+ are there. TB-1 board has tobe pressed down to make charge light come on. | ||
| Sony | CPD17SF1 | NO RED, CAUSED BY IC001 (VIDEO PRE-AMP) | Unit has no red. Found input signal on IC001 is good, but output is very low. | ||
| Sony | CPD15SF1 | FRONT PANEL BUTTONS LOCKED, LOAD DATA TO PC TO UNLOCK | Front panel buttons are locked up only power button works. | ||
| Sony | CPD15SF1 | NO VIDEO, CAUSE BY PUNCTURE ON C617 | unit has no video or video comes up very slow. | ||
| Sony | ZSM1 | WOULD NOT PLAY DISC: REPLACED M701 | Unit was sent in stating it would not play md's. Foundround piece of mech taped to top of unit by customer. Piece fell offspindle motor preventing disc from playing. | ||
| Sony | SSC520AM | REPLACEMENT O RING GOES BAD | One of our customer uses thier SSC520 in a rather extremeenvironment, garbage trucks. SB SEC0048 wqaas performed just over 90 daysago. The o ring has again failed. | ||
| Sony | CFD8 | DECK BUTTONS JAM, CHECK FUNCTION REF#232 | Stop, rew & ff buttons jam due to bent lever pictured. | ||
| Sony | CFD570 | NO POWER | Located some errent solder underneath the board's shieldbetween the ground and JW210, Cauisng the VCC line of IC306 to short togrund. | ||
| Sony | CFD560 | DEFECTIVE/NO CD PLAY: RESOLDER CN806 | No CD operation caused by not enough solder on CN806. | ||
| Sony | CFD540 | WORN OUT TAKE UP REEL, PLATE ASSY: REPLACE | Take up reel plate assy is wearing out, creating grindingnoise in tape deck. -SOLUTION :Replace take up reel plate assy. | ||
| Sony | CFD470 | NO CD OPERATION OR DISPLAY: C765 0PEN | No CD operation, no CD display. Found C765 on CD main boardopen. | ||
| Sony | SLVR5C | TRACKING LIGHT CONTINUES TO BLINK | Erase of ctl and lateral audio track. Looks like bad capstanor drum, hi fi track and picture are visible. Very misleading, biasvoltlage must turn on but cannot find correct pin out that ties the twotogether. -SOLUTION Replace IC501 |