Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SLV575UC | "DQ-2" BOARD | Enclosed is the main board and a DQ-2 board. There is noinformation on this DQ-2 board. | ||
Sony | CDPC35 | NO DRAWER OPERATION WITH NEW "BD" BOARD | With new BD board drawer would not open. | ||
Sony | HVC2200 | NO VIDEO OUTPUT | Camera had no output. Found low voltages on several sourcesproduced by T-1 on C-6 board. 145V source was ok and -6 was ok but +/-110V sources were about one third of normal. We completely unloaded allthe sources with no significant change in voltages. | ||
Sony | KV27EXR15 | DOES NOT RETAIN, OR ERASE SOME MEMORY SETTINGS, ROM IC-102 | Channels 80 through 87 cannot be erased. Trapezoid lookingpicture and top screen sides reduced. When adjusting pincushion phase inservice mode, correction will be achieved but ROM won't retain new settingin memory when unit is unplugged. | ||
Sony | CDPC205 | INTERMITTENT OPERATION | Unpredictable problem sometimes it has run away spindle motor.Sometimes it will not do anything. | ||
Sony | CCDV110 | NO VIDEO ON CAMERA MODE | Recording a while, unit will record audio but no video oncamera mode. Noticed camera power is off, but still VTR is on. Performedbattery down adjustment and its the same. | ||
Sony | XE8 | SPECTRUM ANALYZER DISPLAY IS FULLY LIT | Unit is newer type which uses Supplement 1. It has a problemreferenced in service bulletin No. CAR0128. This unit has the changesin place refered to in the service bulletin, unit has the same symptoms. -HQ COMMENTS: The Supplement 1 revision is not id | ||
Sony | MPF17W55D | AVAILABILITY OF A 3.5 INCH FACEPLATE | The MPF17W55D is a 3.5 inch floppy disk drive that is packagedin a 5.25 inch enclosure. This means that it will physically fit in aslot made for 5.25 inch disk drive. However, there is no kit availablethat enables this disk drive to fit into a 3.5 inch | ||
Sony | KV1941R | TRANSISTOR SUBSTITUTE, Q-605 | Transistor 2SA835 substitutes to 2SA968B. Pin configurationis different. Part mounts on heat sink and subs part will not mount dir-ectly. Is this a good part number. -HQ COMMENTS: Yes, this is a good part number. However, it may benecessary to bend | ||
Sony | D66 | DISC DOES NOT SPIN | When Play button was pressed sled moved and hit limit switchbut spindle motor will not turn. Found coil L-508 was open. This problemis not the first time. | ||
Sony | D11 | DISC DOES NOT SPIN | When play button was pressed sled moved and hit limitswitch but spindle motor will not turn. Found coil L-504 was open. Thisproblem is not the first time. | ||
Sony | D4 | DOES NOT SPIN | When play button was pressed sled moved and hit limitswitch but spindle motor will not turn. Found coil L-504 was open. Thisproblem is not the first time. | ||
Sony | D2 | DISC DOES NOT SPIN | When play button was pressed sled moved and hit limitswitch but spindle motor will not turn. Found coil L-504 was open. Thisproblem is not the first time. | ||
Sony | DTC700 | TAPE MOVES BUT NO AUDIO | Tape moves but no audio. Noticed drum servo speed not locked.(D) reference (pin 60) frequency was low compared to SWP (pin 63) frequen-cy of IC-312. (D) reference is generated by IC-307 by one of the threereference crystals. Found both X-302 and X-303 | ||
Sony | KV2680R | UNABLE TO ADJUST PURITY, COLD SOLDER ON THP-601 | Picture looked like a rainbow. |