Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP90 | AVAILABILITY OF CHARGE TERMINALS | Need part number for reference number 5 on page 31. -HQ COMMENTS: Tokyo Fax (T90116): The part number is as follows. PART NO. DESCRIPTION 3-395-601-01 CHARGE TERMINALThis part is currently available at KCPS.A se | ||
Sony | KX2501 | POOR TO NO OPERATION AT LOW VOLTAGES | Unit started whistling and misbehaving (width problems,pin-cushion, etc.) if voltage was 120V or lower (ok at 121V). | ||
Sony | GEN-TVP | WHITE POWDER ACCUMULATION ON TV UNITS | |||
Sony | SLV272UC | PART NUMBER FOR IC301 CP-1 BOARD | There is no part number in the Service Manual for IC-301. | ||
Sony | TCK950ES | ADDENDUM TO FPR L1264 | Customer has had three brand new units with the same problem.Each evidences a scraping noise, apparently coming from the T-side pinchroller. Repetition rate of noise roughly equals one rotation of pinchroller. On his second unit I replaced the pinch ro | ||
Sony | KPR4110 | P/N FOR THE NEW D BOARD,A-1340-802-A | Servicer found when servicing this unit that the D-board wascracked and ordered a new one. Upon receiving the new board, he noticedthat the new board contained only 6 connectors while the old boardcontained 8 connectors. The only part number in the S/M | ||
Sony | EVS350 | INCORRECT PART NUMBER | Above part number substitutes to 8-719-109-57. This isincorrect as this is a RD2-4ESB2 diode. | ||
Sony | KVX370 | NO OPERATION (POWER ONLY) | Unit appears dead but there is power. | ||
Sony | CDXA30 | NO PLAY | If replacing RF board on unit, there will still be no play. | ||
Sony | CDXR77 | NO EJECT | Disc hangs up before eject cycle is complete. Found loosegear on roller shaft. | ||
Sony | CDXR77 | NO AUDIO | Found connector CN-101 disconnected due to excessive pullingon external audio output cables (CNJ401). | ||
Sony | CCDV101 | NO PLAYBACK RF | Traced problem to HR-10 board not receiving RP-5V on pin 7,however, had 5V on pin 19 (reg 5V) traced problem to L-236 open (236 wouldnot cause problem if the schematic were correct). | ||
Sony | CDXA30 | REVISION OF SERVICE BULLETIN NUMBER CAR0130 | The service bulletin tells you to connect pins 3 and 7 in theRMX2 to cure the distorted audio but in most cases the customer usuallysends in the CDX-A30 and not the RMX2. | ||
Sony | CDPC305 | INCORRECT PART NUMBER - SPINDLE MOTOR | Part number for spindle motor (M-101) is incorrectly listed inthe service manual. | ||
Sony | CDPC205 | INCORRECT PART NUMBER - SPINDLE MOTOR | Part number for spindle motor (M-101) is incorrectly listed inthe service manual. |