Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | CCDF40 | NO PLAYBACK | Scrambled picture. Looks like lost horz. sync. | ||
Sony | HVM200 | DOES NOT OPERATE | The leads on the DC-DC converter board punch through theinsulating sheet and short out on the shield below it. This damagesthe converter. | ||
Sony | XR530R | REPLACEMENT GEAR NOT WORKING | National Parts Center computer substitutes 3-290-741-01 gear.Old part has retainer rib inside hole. The new part does not. New partwill fall off as there is no room on top of the gear to install aretainer. Please advise what is required to complete cu | ||
Sony | KV27XBR10 | VIDEO RESETS, EACH INPUT HAS IT'S OWN RESET FOR VIDEO LEVELS | All the 27XBR Chassis and KPR46CX chassis have individualreset for each video mode. Our Service Centers and independent servicersare not aware of this and they spend time troubleshooting a video 1, 2, or3 video problem (example video 1 is brighter than v | ||
Sony | RM759 | REMOTE CONTROL UNIT FOR KV8AD10 | RM759 is made for KV8AD10. When used with 89XBRs(IC KV32XBR10), functions (Power, Vol., Display), will work. Channelup and down will not work. (Info requested by Dom S.) -HQ COMMENTS: Thank you very much for your information. We will issueService | ||
Sony | KV32XBR10 | NO PICTURE, REPLACED C-515, D-505, AND R-515 | No picture - Found C515 leaky which caused D505 to shortand open R519.C515 = .0047 @ 2KV = 1-162-114-00D505 = ES1F = 8-719-300-65R515 = 212K = 1-215-871-91 | ||
Sony | CDPC70 | DRAWER INTERMITTENTLY CLOSES AT COMPLETION OF OPEN ACTION. | Intermittently the drawer will close as soon as it reachesits open-most position. Holding the drawer from opening all the waydoes not cause it to close. (This is normal). | ||
Sony | CDPC7ESD | DRAWER INTERMITTENTLY CLOSES AT COMPLETION OF OPEN ACTION. | Intermittently the drawer will close as soon as it reachesits open-most position. Holding the drawer from opening all the waydoes not cause it to close. (This is normal). | ||
Sony | WMF109 | PART NUMBERS REVERSED | The part numbers for the WMF 100II and III are reversedfrom the parts in the WMF109. See ref #74 and 97. Which is correct? -HQ COMMENTS: WMF109 Service Manual has the error. Ref 74Part No 3-329-737-01 is labeled as the left guide. It is actually the | ||
Sony | CCDF45 | UNIT SHUTS DOWN, NO EJECT OR PLAY | Unit would not eject or play or record. Would start thenwould go into shut down with eject indicator flashing. Found 5 voltswere missing to the (CC-26) Board which in turn feeds (FP-89) Board and(FP-90) Board which are the take-up and supply reel sensor | ||
Sony | SL2000 | CHANGES SPEED FROM BII TO BIII AND VICE VERSA | With self-recorded tapes speed changes during normalplayback. If unit is on PAUSE, then released, capstan speeds upand accumulates tape then shuts down. Works fine with pre-recorded tapes. -SOLUTIONS: Any suggestions? -HQ COMMENTS: With a unit this | ||
Sony | MDP510 | NO DISPLAY AND SLED MECHANICAL NOISE | When disc is inserted, sled moves into limit switch, butthe sled drive motor does not stop. Also no fluorescent display. | ||
Sony | CMAD5 | VERTICAL ROLL | Vertical roll - 2 units. | ||
Sony | EDV7500 | SHUTS DOWN AFTER TAPE SPEEDS UP (PLAY MODE) | Unit will load tapes, thread, but when you hit play thecapstan will speed up. The unit shuts down due to accumulation of tape.Replaced suspected capstan motor did not solve problem. FG is presentat FG AMP IC-007. | ||
Sony | CPD1303 | MISSING PART NUMBER ON SERVICE MANUAL | The mounting screws for the 9 pin (d type) connector arespecified as part number 768564679. This is the correct mountingscrew for the AC Connector but not for the 9 pin connector. The screwneeded is shown on page 45 of the service manual. It is the sc |