Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | KV8000 | CAPACITOR GETS HOT BECAUSE OF SUB PART NUMBER | Part 1-123-172-11 is being substituted to 1-123-267-00. Thephysical size is smaller than original part, therefore, the capacitorgets hot in the KV-8000. The servicer reports that this has happened onseveral of the sets. -HQ COMMENTS: This is the large | ||
Sony | CVM1270 | INSUFFICIENT HORIZONTAL DEFLECTION | Unit had lost horizontal drive. This caused horizontal drivetransistor, drive transformer, dropping resistor in horizontal circuit toover dissipate. Two coils and a resistor in the power supply had alsofailed. Technician had found and replaced these c | ||
Sony | SLHF1000 | CAPSTAN MOTOR RUNS FAST | After the unit is on for a while, the capstan motor runs veryfast. No clock at pin 2, IC-801. | ||
Sony | SUS49OT | PART NUMBER NOT ON MASTER PARTS LIST | The part number for the confirmat screw, T96522421 is listedin the service manual for the SUS49OT, however, when the part is ordered,they were told to order by model and description. We found that the partnumber is not listed on the master parts list. | ||
Sony | XR7050 | PART NUMBER | Need the part number for CNP901 for parts distributor. -HQ COMMENTS: The part number is 1-574-105-11. Tokyo issued a servicemanual correction, Correction No. 1, in June 1988. | ||
Sony | SLV70HF | TRACKING METER NOT COMING UP ON SCREEN | The tracking meter display does not come up on the screen whentracking. -HQ COMMENTS: If the tape is not a Hi-Fi tape, the tracking meter willnot come on since the unit uses the Hi-Fi signal to develop the trackingindicators. | ||
Sony | CPD1304 | NO PICTURE | When using the VGA wonder card (1056 x 350) in the inhancemode, picture will blank out. -HQ COMMENTS: VGA wonder card drops below 28KHz. This models specs willnot go below 28KHz. | ||
Sony | SLHF360 | TAPE THREADS HALF WAY THEN EJECTS - REEL TABLE WILL NOT TURN | Tape threads half way then ejects. Reel table will not turn. | ||
Sony | KV27XBR10 | RASTER, NO VIDEO, LOSS OF H SYNC, REPLACED IC-531 | Screen displayed raster, no video, severe loss of horizontalsync and severe pincushion distortion. Waveform check revealed no signalat pin 1, IC-531. Resistance check revealed 200 Ohm short between pins1 and 7 of IC-531. Horizontal frequency was also | ||
Sony | DT4 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
Sony | D2 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
Sony | D4 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
Sony | CCDV2 | F-902 KEEPS BLOWING | IRIS stays closed, unit shuts down after a few seconds incamera mode only. F-902 keeps blowing. | ||
Sony | CCDTR5 | MISSING PART NUMBER STEP UP RING/ 3-707-568-01 | Part number is missing for the step-up ring from 37mm to 40mm. -HQ COMMENTS: The part number is 3-707-568-01. | ||
Sony | CCDTR5 | ONLY ZOOMS ONE WAY | Unit only zooms one way. |