Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SLHF300 | SNOWY PICTURE | Snowy picture, receives no channels. | ||
Sony | XR740 | NO AUDIO OR MOTOR OPERATION | No audio or tape operation but AM and FM appeared to function.Found Q302, Q304, Q402, Q404, Q501 and Q601 muting. This was due to IC701Pin 19 in mute state (2.5V). When checking B+ to IC701, it was only 2.5V.Found Q702 collector to be 0V. This is the | ||
Sony | ITA500 | BEEP TONE ERROR | When out button pressed, beep tone error produced. | ||
Sony | LCG396 | BOARD MOD. TO UNIT UNDER TEST: LCG-396/KV-1311CR (RGB MODE) | RGB modified LCG-396 will not work with KV-1311CR or CPDunits. No sync, or blanking occurs. | ||
Sony | ITA500 | UNIT WILL NOT OPEN CONDO DOOR | Unit will not open condo door through the digit #9. Pls letus know why and what should be done. -HQ COMMENTS: This condition is presently under investigation. Toevaluate the problem, we need info on the control network used in thecondominiums. | ||
Sony | XR77 | SCAN ON FM STOPS 0.1 POINT SHORT OF STATION | Scan on FM stops 0.1MHz short of station. Have to turnmanual scan to get on station. Have tried adjusting CT701. -HQ COMMENTS: Adjust controller frequency for 100MHz +/- 3KHz. If youcan not adjust for 100 MHz +/-3KHz, IC701 may be broken. Also check | ||
Sony | SL2000 | NO OPERATION | Unit would thread w/o cassette. Threading motor would notturn off at threading end. Commands (play, etc) were accepted (LED wouldlight) but no operation. After 8 sec unit would go into shutdown, witheject light on. Servicer had previously replaced IC | ||
Sony | LC710 | NEED P/N FOR STRAP AND BATTERY HOLDER | We need P/N of shoulder strap and battery holder used in theBetamovie system case. -HQ COMMENTS: These parts are not available separately. Sales has afew extra parts which I will send to you. | ||
Sony | XR740 | EJECT MALFUNCTION | I have received six or so XR740/780compartment. On none of them could I find a defect. After unjamming tapeand resetting the mechanism, all functions are okay. It seems that thewhite cam gear (#383) hangs up while moving the power plate assy (#371)for | ||
Sony | KV25XBR | POOR VERTICAL LOCKING | Good pix and sync with network broadcast, but with VCR output,poor vertical lock, intmt blanking of pix. Found reduced amplitude ofcomp. video at output of U board (U-10). Signal reduced by 1/3 between Band E of Q822 buffer, but Q822 OK. | ||
Sony | CCDV8 | COLOR DISTORTED | Two units same week. I think this is part of master osc.giving color problem. IC708, CP-9 bd (sync gen) also replaced. | ||
Sony | WMF10II | CORRECT P/N - STOPPER, RETAINER | Request correct P/N for above Ref #, manual incorrect. -HQ COMMENTS: Items #9 & #10 are reversed on the exploded view. There-fore, item #9 on the part # list (P/N 3-315-929-31 Ornament (B) Reel) isthe one you are requesting. See Tape Recorder S/B #19 | ||
Sony | STRVX750 | INTERMITTENT MEMORY, WRONG MEMORY IN PRESENT, NO OUTPUT | 1) Intmt loss of memory @ powered 2) Occasionally a stationnumber would show up @ turn on that was not in preprogrammed memory andhad not previously been selected 3) FM high/low switch inoperative 4)@ turn on, unit had no output until a button (any on | ||
Sony | CPD1310 | NO VIDEO | Circuit board broken on B board underneath of CNJ401 alltraces broken. This is the second set with the same symptoms, and alsoD416, 417, 418 went bad. | ||
Sony | FD40A | POOR VERTICAL SYNC, REPLACED IC201 | Poor vertical sync on TV operation. A/V input OK. Found weakvideo signal at CF201, but DC voltages checked OK on IC201. |