Dicas Reparação





Pesquisa:

Resultados 81712

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyMTL10
LOADING MECHANISM JAMS After a month or two, the loading lever does not enter intothe groove on the cam gear. This in turn causes the loading mechanism tojam and subsequent inoperation of the unit. -HQ COMMENTS: Check for slippage between gear A (Item No. 3), O-ring(Item No.
SonyCFSF11S
PLAY MODE WILL NOT OPERATE Unit locks up when put in play. Head deck appears to bebinding. Everything seems to be free when taken apart. Need operationalprocedure and troubleshooting guide. -HQ COMMENTS: Check if the NR slider moves. If not, check the FWD camgear and the reve
SonyCFSF11
CRACKED GEAR Cracked gear.
SonyCDP701ES
REMOVAL OF SHORTING CLIP Even though new OPB was installed, unit did not operate.
SonyCDP701ES
CHUCKING MOTOR SWITCH NOT ENGAGED The unit rejected the disc intermittently. Opened the unitand found the chucking operation was not done, when we closed the disctable.
SonyXR25
REPLACEMENT PART IS TOO SMALL Per HQ's comments for my FPR, I ordered the sub. spring(P/N 3-317-637-01). But it is too small as a sub for the original(P/N 4-303-774-xx). -HQ COMMENTS: 3-434-137-02 is a correct number. KCP does not have instock presently. We will issue a T/N soon.
SonyXR15
POOR CONTACT AT CONNECTOR Intermittent audio (FM only). This was present w/radio andtape modes. I have seen two XR-15s with this problem.
SonyWMD6
DIRTY SWITCH CONTACTS We have been seeing guite a few units with low voltage onplayback. The problem is caused by dirty contacts on S902/playback mute.A little emery paper and a drop of lubricant (TV tuner type) resolvedthe problem.
SonyWM7
SWITCHES NOT IN PLACE CP801 latches up. Grounding emitter of Q303 RESETS system,when condition appears. -HQ COMMENTS: After a command such as REW is activated, feedback tothe CP801 control circuit on the flex board must return or the CP801latches up. The feedback for the c
SonyTCK60
LOOSE BUSHINGS Distortion on P/B with 3KC WS-48B. Speed OK but sounds likean electronic oscillation problem.
SonyTCK60
BUSHING POST CAP WEARS OFF A varying drag on the supply reel causes wow and flutter.
SonyTCFX500
WORN CAPSTAN BEARING The customer complained of an intermittent pop in bothchannels when playing the tape in the reverse direction. We found thecapstan bearing (reverse direction) to be providing a poor ground.
SonyTCFX45
WORN THRUST RETAINER This unit skewed TDK SA and MAXELL UDX tapes at the verybeginning. We found that there was too much play in the capstan. Thiswas caused by the plastic thrust retainer becoming slightly distorted.
SonyTAP7F
REPLACEMENT XSISTOR LEADS TOO SHORT National Parts Center is substituting 2SA1141 for 2SA1097and 2SC2681 for 2SC2571. The substitute transistors have leads that aretoo short.
SonySTA7B
POOR SOLDER CONNECTIONS Intermittent display and stations drifting.



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads