Dicas Reparação





Pesquisa:

Resultados 81711

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyKV1945RS
NO UHF Q008 SHORTED Would not receive UHF channels.
SonyKV1945RS
INCORRECT TUNING, REPLACED X003 No channel indicator (blank), no tuning of signal. Voltageson IC001 and IC002 were all wrong. Servicer had changed both chips andchecked the clock freq. of IC001 CL1 with a counter, 400kHz. When clockwas finally checked with a scope PP V was only 0.5V
SonyKV1923
NO PICTURE, HAS SOUND, REPLACED C516 No picture, just sound.
SonyKV1922
PICTURE NOISE Three inches wide bar at right side of screen top of bottomonly on HBO cable channel and only at customer's home only on thisparticular unit, other units tried and work fine. Servicer blamingcable co. Found 150pF capacitor between Q512 collector and gr
SonyKV1915
PICTURE DISTORTION One and half inches of top of picture is black.
SonyKV1912
TUNER LOCKED ON CH 2 Tuner locked on channel 2.
SonyKV1910
PICTURE STRETCHING AFTER WARM UP Picture stretches vertically after about one hour operation.
SonyKV1512
DEAD This unit initially appeared to have a shorted SG613 and2SC867. Upon powering up the set with a DC supply it was noticed thatthe waveforms were irregular. Closer examination revealed R522 hadchanged in value.
SonyKP7220
KEYSTONE, REPLACED D5313, D5312, Q5537 Keystone effect on all three tubes. Pix normal at top butnarrow at bottom.
SonyTV790
H PICTURE DISTORTION Horizontal frequency changes after short warm-up.
SonyTV123
NO PICTURE Q502 runs red hot for about one week and then fails, causingno raster.
SonyKX1901
V FOLDOVER ON THE BOTTOM Severe foldover on bottom.
SonyKV2648R
GRAY BAR ON THE SCREEN Gray bar very dark on left side and becoming lighter lookingtoward right side of CRT.
SonyKV2647R
JAILBARS, POOR GROUND ON "S" BOARD Jailbars present on left side of screen more pronounced onthe higher channels. Found poor ground on S board opposite the groundingposts from the tuner.
SonyKV2647R
NO VERTICAL SWEEP, REPLACE RV2206 No vertical sweep. Voltage at IC501 Pin 11 should be 6.3 VDC.Actual reading was 2.2 VDC. Found vertical hold control had an 8000 ohmreading center tap to case at all times.



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads