Veja se ajuda.
Error codes
Error code Error code interpretation Probable malfunction of the washing machine
E00, E01 Drain from washing machine
The filter of the filter of the washing machine.
E02 Incorrect drain / fill of water and spin
Incorrect drain hose position - system malfunction.
E03 There is no discharge of water from the tank or the drainage time has been exceeded (more than 3 minutes) A technical malfunction, which in any case should be addressed to the service center for household appliances maintenance
F2 Temperature sensor Problems in the temperature sensor, in the control module or in the heating element
F4 There is no water drain Problems in connecting the drain hose, malfunction in the drain pump. It is necessary to replace it.
F5 Simultaneous drain and set of water The drain hose is not properly connected, there are problems in the water supply filter.
F6, F6, F12 There was a water overflow in the tank of the washing machine. Malfunction of the module or motor.
F8 Excessive water level in the tank Problems in the water level sensor - problems with the solenoid valve.
F13, F14 Problems in the water level sensor - problems with the solenoid valve. Critical errors, inform about the malfunction of the electronic control module.
Reset
A Models:
Step 1
Reset your washing machine by pressing the "Off," button, waiting one minute and then pressing the "On" button.
Step 2
Reset the control panel by holding down the "Back" and "My Cycles" buttons concurrently for three seconds and then releasing.
Step 3
Write down any errors displayed in case your washing machine ultimately needs a service call, using a pencil and paper. If the word "More" is displayed, press "More" to identify the rest of the errors. When the display says "Exit," press "Exit."
Step 4
Unplug your washing machine and plug it back in right away.
Step 5
Press the "Power" and the "Start/Stop" button concurrently when the machine powers on until the home screen pops up, signaling that your washing machine has been successfully reset.
B Models:
Step 1
Unplug your washing machine for 30 seconds.
Step 2
Plug your washing machine back in, and after 30 seconds, push the "Pause/Cancel/Stop" button two times. Choose a wash cycle.
Step 3
Press the "Start" button until the wash cycle begins to ensure that the washing machine is functioning properly.