| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| PANASONIC | TX14S2T | LACK OF HEIGHT WITH FOLDOVER | REPLACE R521 8.2 OHM | ||
| Panasonic | TX14JT1 | BBC1 lost on chan 1 but would retain it on another chan | EEPROM IC1205 pt no X24S11-1MAZ | ||
| Panasonic | TX14GV1L | Locking up | The official remedy for this fault from Panasonic is to replace both the main microprocessor (I701) and the EAROM (I703). The new part numbers for these are:- I701 MS5457CU1, I703 X24C-14GV1 | ||
| Panasonic | TX14GV1 Z421V | Int reverts to st/by | Replace TOP210PFI standby control chip (I807) and I.R. Receiver module (IQ01 | ||
| Panasonic | TX14GV1 Daewoo CP421 | Relay clicking No sound or vision | Check C840 47mfd and I807 TOP210PFI | ||
| Panasonic | TX14GV1 | text lines on the top | EAROM IC703 FAULTY, PART NO. AT24C0810PC | ||
| Panasonic | TX14GV1 | No pic - int comes on with bang - sound ok | Invisible crack in print at LOPTr coll | ||
| Panasonic | TX14GV1 | Dead with mains relay clicking continuously. | Replace 47uF 25V (C840) in standby supply circuit. | ||
| Panasonic | TX14B4T | No signals found when tuning | Earom replacement IC702 24C14 & mod kit fitted | ||
| Panasonic | TX14B3T Z375 chassis | Field collapse noticed when A1s advanced | IC301 TDA8456 - also do following mod - change C309 to 22µ 100v, add 0µ01 across R310 & fit 2R2 1w in place of jumper R420 | ||
| Panasonic | TX143T Z375 Chassis | Tripping - st/by led flashing | LOPTx | ||
| Panasonic | TC862G | Line hold drift. | C505 ( 1u f ) | ||
| Panasonic | TC800G | Frame collapse. | C407 ( 3.3uF , 16v ) tantalum. | ||
| Panasonic | TC486 | Line hold drift. | C505 ( 1u f ) | ||
| Panasonic | TC481 | INT LOSS SIGNALS | R545 DRY |