| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CPD1304 | NO PICTURE | When using the VGA wonder card (1056 x 350) in the inhancemode, picture will blank out. -HQ COMMENTS: VGA wonder card drops below 28KHz. This models specs willnot go below 28KHz. | ||
| Sony | SLHF360 | TAPE THREADS HALF WAY THEN EJECTS - REEL TABLE WILL NOT TURN | Tape threads half way then ejects. Reel table will not turn. | ||
| Sony | KV27XBR10 | RASTER, NO VIDEO, LOSS OF H SYNC, REPLACED IC-531 | Screen displayed raster, no video, severe loss of horizontalsync and severe pincushion distortion. Waveform check revealed no signalat pin 1, IC-531. Resistance check revealed 200 Ohm short between pins1 and 7 of IC-531. Horizontal frequency was also | ||
| Sony | DT4 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
| Sony | D2 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
| Sony | D4 | NO LASER IN NEW OPTICAL DEVICE | There is no laser in a new optical pick-up device. Pin 9 andpin 8 are shorted in factory. All new FOP (optical pick-up devices) havethe same problem. | ||
| Sony | CCDV2 | F-902 KEEPS BLOWING | IRIS stays closed, unit shuts down after a few seconds incamera mode only. F-902 keeps blowing. | ||
| Sony | CCDTR5 | MISSING PART NUMBER STEP UP RING/ 3-707-568-01 | Part number is missing for the step-up ring from 37mm to 40mm. -HQ COMMENTS: The part number is 3-707-568-01. | ||
| Sony | CCDTR5 | ONLY ZOOMS ONE WAY | Unit only zooms one way. | ||
| Sony | CCDTR5 | DEAD UNIT | Unit came in dead. | ||
| Sony | CCDTR5 | CAMERA SECTION DEAD | Camera section dead, VTR is ok. | ||
| Sony | CCDTR5 | EATS TAPES | Unit eats tape. They were catching on the take up reel. | ||
| Sony | CCDV99 | PICTURE BLANKS BRIEFLY DURING INSERT EDIT | When an insert edit is done through the composite video inputs(not HI8) onto a tape with HI8 recording, a problem occurs on playback onthe inserted portion. At the edit points there is a glitch where the pic-ture blanks quickly. The edit is not a clean | ||
| Sony | TCRX400 | PCB LAYOUT DIFFERENCES | PCBs differ in these two tape decks. Both PCBs differ fromthe layout in S/M. Is there a S/M supplement? -HQ COMMENTS: There are no supplements published. I will ask Tokyofor information on changes and respond to you. There is an extra jumperground | ||
| Sony | MDP700 | LINES IN VIDEO | Noise lines in video while playing, but not in pause or stopmodes visible in color or black and white pictures. |