| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | SLHF1000 | NO OPERATION (DEAD) | The 9V and 12V from IC-002 were missing. Found C-024 (47uf)at pin 15 shorted. | ||
| Sony | SL2710 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2700 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2500 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2400 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | KV2649RX | ANTENNA CHANGE SWITCH | This part is no longer available. What do we use as asubstitute for this part?-HQ COMMENTS: Please see service bulletin number 61. | ||
| Sony | FD500 | PART NUMBER FOR CHARCOAL GRAY KNOBS MISSING | There are no part numbers listed in the service manual for thecharcoal gray knobs. | ||
| Sony | KV1953R | D-510 LEAD WAS TOO SHORT | D-510 lead was too short. Not through PC board. | ||
| Sony | SLHF450 | NO BETA HI-FI | No Beta Hi-Fi or Beta Hi-Fi light. Regular audio is ok. Wehave three reports of this. | ||
| Sony | PBR330 | PART NUMBER NEEDED | I need the part number for the microphone holder that goeswith a PBR330 parabolic reflector. -HQ COMMENTS: The following part numbers must be ordered: 2-212-424-00,2-212-425-00 and 2-212-426-00. Please note that since this is not a U.S.product there wi | ||
| Sony | TCW530 | PART NUMBER | Need the part number for S901, S902 for a TCW530. -HQ COMMENTS: The part number is 1-570-720-11. This number came from aFH-50WX service manual which has the same deck. | ||
| Sony | TCRX50ES | CHANGE IN MECHANICAL CHASSIS ASSEMBLY | Part supplied by Kansas City (X-3343-418-1) is different.Eject safety lever (Ref. 111) does not fit properly. | ||
| Sony | SPP50 | HANDSET SPP-50 | Very poor reception. Handset could only be used within a 3foot range of base. | ||
| Sony | KV1929RA | NO PICTURE, NO SOUND, BOARD CRACKED | |||
| Sony | KV1217 | UPC1358H, SUB TO UPC1368H2 | After replacing the vertical output IC twice, we still had novert. operation. We tried using an RCA substitute P/N SK-9180. This IChas worked fine. -HQ COMMENTS: We do not usually recommend using a non Sony replacementpart - but the UPC1358's substit |