| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | STR313 | REPLACEMENT IC CAUSES DISTORTION IN OUTPUT | After replacing the tone/power amp SI1125HD (P/N 8-759-301-25)with its perscribed replacement, the new IC produced noiseon the output. Tried another replacement and problem remained. Alsoremoved the capacitors as discribed in HI-FI bulletin 116 to no a | ||
| Sony | SLV555UC | CHANNELS CONSTANTLY CHANGING | As soon as power was turned on, channels would start changingdown as if you were holding the channel down button down. | ||
| Sony | SLV555UC | NO FF/REWIND/PLAY | Complaint of no tape movement on unit. Changing the MD-22board from another unit to this unit would make this unit operate ok. Thetechnician had inherited this unit from another technician with PH-001 andPH-002 out. He had installed the sensors by com | ||
| Sony | KPR4110 | INTERMITTENT SHUT DOWN, REPLACED C-5058 (E BOARD) | Unit would intermittently shut down. After finallydetermining it was in protect, the horizontal out transistor waveform wasmonitored. It was discovered to be distorting intermittently. | ||
| Sony | CFS710 | PART NUMBER FOR GEAR NOT SUPPLIED IN SERVICE MANUAL | The gear shown beneath Reference No. 173 on page 22 of theservice manual is listed as not supplied. | ||
| Sony | TCWR808M | INTERMITTENT/NO TAPE OPERATION | TCWR808M with TA-808M. Installed larger cap C418. Unitpowered up but decks worked erratically. Found new Reg. board in TA808M.Open F-906 causing ripple to TC to be high. With F-906 fixed, mod. was notneeded. F-906 seems too small of a value. Blows when | ||
| Sony | XR6500 | INCORRECT PART NUMBER IN SERVICE MANUAL, IC-2 | The part number in the service manual for IC-2 is incorrect. | ||
| Sony | CFSW402 | TAPE SQUEALS AT END OF TAPE | Unverified problem. Servicer reports that squeal occurs dur-ing auto-reverse at end of tape. Using TDK SA90 tape, capstan seems to beslipping on leader. | ||
| Sony | XTV5 | MISSING PART NUMBERS | Service manual has picture of remote control (page 4) but man-ual does not identify remote control part numbers. -HQ COMMENTS: The remote control used with the XTV5 is model numberRM-X5. The service manual for the RM-X5 lists the part numbers. | ||
| Sony | RMP700E | INCOMPATIBLE PART - UPPER LID ASSEMBLY | Replacement part is physically different than original doorassembly. Hinge area, left and right on new replacement part hinge area,left and right on new replacement part has additional plastic which willnot allow replacement. Original door is open ende | ||
| Sony | RMP700A | INCOMPATABLE PART - UPPER LID ASSEMBLY | Replacement part is physically different than original doorassembly. Hinge area, left and right on new replacement part has addi-tional plastic which will not allow replacement. Original door is openended on left and right hooks. The replacement part | ||
| Sony | KP36XBR | NO KEYSTONE ADJUSTMENTS POSSIBLE | No keystone adjustments possible. RV-6024 and RV-6033 had noeffect on keystone adjustments. | ||
| Sony | RMX2 | PC BOARD CHANGES | There is a difference in the B and C connectors and wiringwhen going from first version of the main PCB to a version like in theSupplements 1 and 2. Is there a solution to this problem other then re-wiring B and C connectors on this unit? | ||
| Sony | SLV575UC | INTERMITTENT PLAY AND EJECT | Cam motor and loading motor would only drive in one direction. | ||
| Sony | KV27XBR15 | PART NUMBER FOR CABLE FROM A82-C82, 1-508-768-00 | Is the 6 pin cable between the A-82 connector and the C-82connector available and if so, what is the part number? -HQ COMMENTS: Please see Pg 92 of your service manual under C-board(Connectors). You will see C82, P/N 1-508-768-00, Connector (5mm pitch) |