| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | WMF2097 | POOR SOLDER CONNECTION AT BATTERY TERMINAL | The negative battery terminal on this model often has a poorsolder connection. | ||
| Sony | WMA602 | POOR SOLDER CONNECTION AT BATTERY TERMINAL | The negative battery terminal on this model often has a poorsolder connection. | ||
| Sony | WMAF604 | POOR SOLDER CONNECTION ON BATTERY TERMINAL | The negative battery terminal on this model often has a poorsolder connection. | ||
| Sony | WMF2085 | NO P/N FOR BELT CLIP LISTED IN S/M | The P/N for the belt clip supplied with the unit is not listedin the Service Manual. | ||
| Sony | CFD444 | SERVICE MANUAL ERROR - VOLTAGE ON Q-711 | One of our servicers detected an error in the service manual.While troubleshooting the unit, he measured 3.7 VDC at the emitter ofQ-711. The manual has it listed as 7 VDC. -HQ COMMENTS: You are correct. Thank you for pointing this out to us.The manual | ||
| Sony | CDP101 | DOOR WON'T OPEN/GREASE HARDENED | Door won't open. Lever 165 (page 66) won't go back to restingposition which allows door to open. There is a spring on this lever whichis to pull it back into resting position. The problem is the grease thatis on the shaft has hardened and turned to gl | ||
| Sony | CCDV99 | NO VIDEO PLAYBACK OF HI-8 METAL E TAPES | No video in playback mode with use of Hi-8 metal E tapes.Only a gray screen with audio. | ||
| Sony | CCDTR7 | NO ZOOM | Zoom block assembly was frozen. Took apart and tried to freeup, but to no avail (part not supplied). | ||
| Sony | KPR46CX10 | SNOW WHEN CONNECTED WITH CABLE CONVERTER, REPLACED CABLE BOX | When connected as shown in owners manual, with cable converterthe picture will be snowy. Also tested KV-27XBR10 on same location andproblem did not show. -HQ COMMENTS: Found that the customers cable box was not puttingout the signal at channel 3 freque | ||
| Sony | XM601 | NO OUTPUT | No output because of no power. | ||
| Sony | CCDM8U | UNIT WILL NOT LOAD- POWER LED FLASHES | Unit will not load or unload. | ||
| Sony | SL810D | NO PART NUMBER FOR LOWER DRUM ASSEMBLY | Part number is not given for lower drum entire assembly notavailable. | ||
| Sony | MDP333 | NO OPERATION | No display/spindle motor spinning counter-clockwise. Alsoapplies to serial number 816851. | ||
| Sony | CCDM8U | NO CAMERA VIDEO IRIS IS OK | Unit had no record Y signal. Signal out of pin 15 of the ED11(Rec Y) was not there. Tried to inject video from a generator and foundED-11 board shorting out signal. Lifted pin 15 of the ED-11 board toconfirm the problem. | ||
| Sony | KV27AVR | NO AUDIO, REPLACE D-601 | No output from any audio input. Display showed volume controlbut no balance control. Found D-601 shorted putting 15V on pin 23 ofIC-601. |