Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | SPP100 | MISSING P/N - MOUTHPIECE SPEAKER | Need P/N for SP201 on Page 28 and also for flex board. -HQ COMMENTS: P/N for flex PCB is 1-618-500-11. It is reference #910.SP-201 is included in the front cabinet assthe cabinet is incorrect in the S/M. It should be X-3327-409-1. | ||
Sony | TCK96R | NO P/N FOR PANEL, CASSETTE HOLDER | Manual shows no part number for panel, cassette holder. -HQ COMMENTS: The part number is 3-558-343-00. | ||
Sony | VCT150K | P/N FOR LOCK LEVER - LEFT SIDE | Page 4 of S/M shows Ref. No. 7 (2-391-606-00). However, thisP/N is for lock lever - right side. We need P/N of lock lever - left side(The threads are opposite LL-R). Please advise. -HQ COMMENTS: P/N is 2-392-808-01. A S/B will be issued shortly. | ||
Sony | CCDV8AFU | ALIGNMENT METHOD INCORRECT | On page 205 of S/M, adjustments in AF section 1-34-3 areincorrect. Test point for 5.5V adj. should be collector of Q022, notemitter. VCF adj. is unclear. D001 cathode must be shorted to 1.7V line.Also, in offset adj., it specifies shorting 1.7V line t | ||
Sony | WM10RV | GEAR GRINDING AND NO TAKE UP TORQUE | This unit had a gear grinding noise and there was no take uptorque. | ||
Sony | KV20XBR | HORIZ AND POWER SUPPLY CIRCUITS | No raster, no sound. Sleep light comes on at power on, andstayed on until power off. Power supply (GA and GB boards) not function-ing properly (no output osc. running off freq.). | ||
Sony | SLHF900 | TUNER LOCKS UP | After several (3-4) hours of use, tuner locked up, i.e.channel change impossible. | ||
Sony | SLHF900 | SHUTDOWN DURING PLAY | Auto stop during play. | ||
Sony | KV25XBR | DEAD | Set would shut down after coming on. | ||
Sony | KV2680R | V JITTER WITH COPY GUARD TAPE, CHANGE R-854 TO 390 OHM | This unit had dark picture and vertical jitter on copy guardtapes played on a VHS VCR. | ||
Sony | FD2A | NO FOCUS, RESOLDERED C806 | Picture out of focus, unable to adjust, traced problem toC806. Found one side of filter capacitor not soldered. | ||
Sony | CDP70 | UNIT WOULD NOT PLAY THE DISC | Unit would focus but would not read TOC. TE test point showederratic wave form but grounding IC102 Pin 13 showed good traverse waveform. Pressing on PCB near IC102 would cause proper operation. | ||
Sony | KPR36XBR | NO PICTURE OR SOUND, REPLACED D-603 | No pix, no sound. Sleep LED turns on and off when powerswitch operated. | ||
Sony | XR44 | NO SOUND WHEN PLAYING TAPE | Radio operation OK but tape muted. Also, inhibited screendisplay of direction, Metal, and N.R. during tape operation. | ||
Sony | WMF80 | NO SOUND OUT OF UNIT BOTH ON RADIO AND TAPE | Graphic equalizer unit is not making contact with main boardthru CN302. Ribbon is just laying inside unit without being into contactsof CN302. |