Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
---|---|---|---|---|---|
Sony | XR780 | DEAD OUT OF THE BOX | Unit turns on and lights up but is muted. | ||
Sony | KV2675R | INTERMITTENT LOSS OF PICTURE OR RETRACE LINES, CR PIN CONN | Set would intermittently loose picture or get retrace and attimes go out of focus. This is a serious problem as it is not easilydetected. I suggest an immediate S/B. | ||
Sony | SPP22 | HANDSET DEFECTIVE - NO CONNECTION TO BASE | Handset beeps as if distance between base and handset is toogreat. Also when handset is in cradle it cannot be called by call button. | ||
Sony | CDP650ES | DRAWER WON'T OPEN | Drawer would not open after inserting a disc upside down. | ||
Sony | CDP70 | NO DISC ROTATION - PART MISSING | Part missing on chucking arm assy. Nowhere to be found inunit, with part missing chucking arm puts too much pressure on disccausing no rotation. | ||
Sony | D5 | JAMMED FR BUTTON | FR button was jammed in causing unit not to start. | ||
Sony | PCMF1 | MUTING | In 14 bit mode unit works correctly. In 16 bit mode, unitmuted. | ||
Sony | KV2681R | NO RASTER/SOUND, HI VOLTAGE OK, LEAKY C-049 ON X BOARD | Set could be turned on, H.V. would come on but no raster, nosound. Found no reset at Pin 18 of IC031 on X board. This is thesecond set I have worked on with this problem and the same part wasdefective. | ||
Sony | KV5100 | NEED'S PART # FOR BRACKET UHF TUNER | I need part number and availability of bracket for the UHFtuner. -HQ COMMENTS: The P/N for the UHF tuner bracket is 4-309-327-05, butit is not, and will not be available. | ||
Sony | D5 | TRACKING NOT WORKING | In service mode, tracking balance waveform is good but wouldnot turn tracking on when MODE button is pushed. Unit did not track. | ||
Sony | CDP30 | SERVICE MANUAL CORRECTION | Adjustment mode for E-F balance adjustment shows groundingvariable contact point of RV103, this should be RV104. The test iscorrect, however the picture of the PCB is not. -HQ COMMENTS: We will issue a S/B. | ||
Sony | WM10 | SUPPLY REEL ASS'Y | Even with the thinner washers, it has been found that thesupply reel gear, wheel block assy, and motor chassis assy will not gotogether. Caused dragging and washer and stopper will not go on shaft. -HQ COMMENTS: Washers are used to adjust clearances on | ||
Sony | CDP302 | COMPACT DISC PLAYER | Skips intermittently, track 6 or higher, not always in thesame place. A mylar sheet is already in place inside the bottom panel toreduce drag on the flexible connector from BU-1. | ||
Sony | SL10 | NEGATIVE PICTURE | Negative picture and no sync on E-E and PB. | ||
Sony | SLHFR70 | INTERMITTENT NO TUNER AUDIO | No tuner audio from TI-5 board. Pin 11 (tuner audio mute) ofIC301 on SA-10 board was high. It could be intermittent. |