| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV8AD10 | NO POWER | No horizontal drive. | ||
| Sony | KV32SXR10 | TWO INCH BORDER AROUND PICTURE, LEAKY Q-1560 AND D-1502 | Unit had a two inch border around picture. | ||
| Sony | CCDTR5 | CAMERA WILL NOT LOAD | Camera will not load. This is the second camera with this. | ||
| Sony | GV8 | RECORD KNOB | Record knob is not available. It is necessary to order entirepanel items yet the power knob, which is almost the same is available,items 12 and 10. | ||
| Sony | XR7180 | UNIT APPEARS DEAD | The unit appears to be dead but does have some LEDs on. Someof the supplies are low. This is due to an open emitter-base junction ofQ-317. Leakage through R-363 makes the circuit look loaded down. | ||
| Sony | TCWR510 | WRONG PART NUMBER | Part number for Q-701 is not in the Kansas City Parts system. | ||
| Sony | KV25XBR | SCHEMATIC ERROR REGARDING V-PULSE | From connector A-2 pin 3 on the V-pulse does not correctlyfind its way to IC-103/pin 4. After being inverted at Q-127, its showngoing to IC-103 pin 15, FM trap pin 4 is shown tied to power switch line. -HQ COMMENTS: Thank you very much for your report. | ||
| Sony | FD500 | NO RASTER - AUDIO OK, REPLACED OPEN C802 | No horizontal pulse at collector of Q-802. A horizontal pulsewas present at base of Q-802. Collector voltage was 9VDC and the basevoltage was -3.4VDC. | ||
| Sony | KPR46CX50 | NO WHITE BALANCE ADJ. IN SM, SEE CORRECTION -1 | Several complaints from servicers about incorrect whitebalance. Service manual does not contain white balance adjustmentprocedure. -HQ COMMENTS: See Correction-1, or use the white balance adjustmentprocedure contained in the KPR-36XBR service manual. | ||
| Sony | KPR41DS2 | WHITE BALANCE, REFER TO CORRECTION 2 | Several complaints from servicers about incorrect whitebalance. Service manual does not contain white balance adjustmentprocedure. -HQ COMMENTS: For the White Balance Adjustment see KPR-41DS2/Correction-2 P/N 9-963-993-92. | ||
| Sony | KPR41DS1 | WHITE BALANCE ADJUSTMENT WRONG,SEE CORRECTION NUMBER 2 | Several complaints from servicers about incorrect whitebalance. Service manual does not contain white balance adjustmentprocedure. -HQ COMMENTS: Please see SM correction number 2. | ||
| Sony | KPR46CX10 | WHITE BALANCE, SEE SM CORRECTION # 1 | Several complaints from servicers about incorrect whitebalance. Service manual does not contain white balance adjustmentprocedure. -HQ COMMENTS: For the White Balance Adjustment Procedure see KPR-46CX10/Correction-1, P/N 9-964-100-91. | ||
| Sony | TCS430 | HEAD WIRE TOO THICK | Shielded cable from the PC board to the tape head opens on onechannel. Wire I have will solve the problem but it is too thick and in-terferes with the mechanism and buttons of unit. Not provided with anykind of head wire to solve these problems. Is or | ||
| Sony | SSM910 | WRONG PART NUMBER | IC-501 is listed in the manual incorrectly as 8-729-262-72. -HQ COMMENTS: The correct part number is 9-991-577-01. | ||
| Sony | XK8D | PCB CHANGE: MOTOR, REGULATOR | The Motor PCB and the Regulator PCB are no longer availablefrom Kansas City Parts. Newer units have a combination type of PCB. |