Dicas Reparação Sony





Pesquisa: sony

Resultados 18959

MarcaModelo
(Chassis)
SintomaCausaSoluçãoPor:
SonyGEN-TVPSNIFFER (RADIO SHACK, SOUND LEVEL METER) Purchased a unit and found it is very useful in determiningsquealing yokes, CDP tracking noises and even camera noises. Like every-thing else, it has to be used correctly. For one thing an extender isneeded. The extender should be made of styrofoam or
SonyCCDF40VIDEO ROLLS IN CAMERA MODE Video rolls in viewfinder and monitor.
SonyCDPC35DAMAGED LOADING GEAR Unit does not open/close properly, or will close, openslightly and then close again.
SonyKV32XBR50SET GOES INTO OVP INTERMITTENTLY ON TURN ON, REPLACED Q651 Set goes into OVP intermittently on turn on (every 4 or 5times). When unit works, all voltages are correct.
SonyKV27HSR10SET GOES INTO OVP INTERMITTENTLY ON TURN ON, Q0651 OPEN Set goes into OVP intermittently on turn on (every 4 or 5times). When unit works, all voltages are correct.
SonyKPR4600AALL CHANNELS WORK OK EXCEPT ONE, REPLACED IC-002 All channels work except No. 3 (audio good) had display.
SonyTCWR80ESHUM Found the top popped on C-712.
SonyRMP201FAILURE OF REMOTE AFTER JUST A FEW MONTHS, REPLACED BATTIRES The customer complained of repeat failures of his remotecontrols. He had received three exchange units with the same results.
SonyXR7400PREVIOUS VOLUME LEVEL NOT REMEMBERED WHEN UNIT IS REMOVED Customer complained of intermittent change in volume levelwhen moving unit between his car and motorcycle. Dealer exchanged unit &new one was the same. Our SSC exchanged unit & new one was the same.
SonyCFD760WRONG PART NUMBERS FOR MOTOR M-601/M-602 Above part number is for the pulley assembly, reference number360.
SonyCFD750WRONG PART NUMBER FOR MOTOR M-601/M-602 Above part number is for the pulley assembly, reference number360.
SonyXK8DPM-401 PLUNGER JAMS CAUSING Q-603 TO BE DAMAGED PM-401 plunger jammed and damaged Q-603. Also applies toserial numbers 10917 and 19158.
SonyKV27XBR60SET GOES INTO OVP INTERMITTENTLY ON TURN ON, REPLACED Q-651 Set goes into OVP intermittently on turn on (every 4 or 5times). When unit works, all voltages are correct.
SonyCDP390NO SLED MOTION WHEN DISC IS LOADED When turned on, the unit would power up and load the disc butthe sled would not move in.
SonySLV50RF MODULATOR AUDIO SIGNAL PATH IN SLV-50 Since the SLV-50 does not have the HF-6 board (for Hi-Fiaudio) to provide audio to the RF modulator (CN-553) a 6.8K Ohm resistor(chip component) is connected between pins 11 and 8 of CN-571 on theMA-27 board. This information is not shown in the service



Assistência TécnicaAs dicas apresentadas destinam-se a técnicos de eletrónica, a tentativa de reparação ou assistência sem ter conhecimentos de eletricidade e eletrónica, podem provocar danos mais graves aos equipamentos e, devido a tensões muito elevadas em alguns circuitos, graves danos fisicos que podem constituir um risco em determinadas reparações.

Não arrisque reparar equipamentos com tensões elevadas se não tiver conhecimentos técnicos para o fazer em segurança.

Verifique se o esquema está disponível na área de downloads