| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CCDF33 | PART NO IC-503 CO2 BOARD | The replacement part is smaller than the original and doesnot fit. | ||
| Sony | CCDF45 | PART NO - IC503 CO-2 BOARD | The replacement part is smaller than the original, and doesnot fit. | ||
| Sony | CCDTR5 | CAUTION LIGHT COMES ON AFTER A FEW SECONDS | Take-up reel stops after a few seconds and caution light comeson. | ||
| Sony | EVCX10 | EVF CABLE TOO SHORT | EVF cable is too short. -TO TOKYO: When ordering the EVF cable part number 1-556-824-61, thereplacement sent is about 4 inches (100mm) long. However, the originalpart is about 7 inches (about 165mm) long, and the replacement is tooshort. Can you pleas | ||
| Sony | CCDTR5 | PART NUMBER FOR PLASTIC SHIELD | I need the part number for the clear plastic shield on thecassette compartment. -HQ COMMENTS: The part number for this shield (called the CassetteCover) is 3-736-834-01. | ||
| Sony | KV27XBR60 | VERTICAL BARS BEHIND PICTURE AFTER WARM-UP, REPLACED CM-1301 | During warm-up, three vertical bars would appear evenly spacedacross screen, each about two inches wide, first dim then progressivelydarker, TV or video in even with no signal source. Using black rastersource, found input to CM1301 ok, but outputs (Y an | ||
| Sony | SPP110 | ID TRANSFER BETWEEN BASE AND PORTABLE CANNOT BE COMPLETED | Will not assign security code when handset is placed on base. | ||
| Sony | XR7100 | BALANCE AND FADE NOT WORKING PROPERLY | Balance and fade not working properly. Customer wired harnesson unit to install in car. | ||
| Sony | KV32CX10 | HORIZONTAL LINES TOP AND BOTTOM OF PICTURE, REPLACE C-1548 | Two horizontal lines top and buttom of picture will fade some-what as set warms up. It will also be effected by adjusting the verticalsize control. | ||
| Sony | CCDTR5 | DRUM REVERSES AND UNLOADS TAPE | When in rewind, drum reverses. When loading the drum slowsdown, then the tape is unloaded. The unit first came in with multipleproblems from an authorized servicer. The above problem occured when theVS-22 board was replaced. | ||
| Sony | CDPC100 | DISC JAMMED INSIDE | Disc jammed when going into magazine after play. | ||
| Sony | CCDF36 | NO ZOOM | Camera had no zoom functions. | ||
| Sony | KV27HSR10 | NO COLOR IN TV MODE BUT OK USING VIDEO MODES, SEE TVP SB 39 | Unit displayed colors in Video Modes but not in the TV (tunermode). Chroma signal was present up to IC301 (Jungle Chip) in both modes. | ||
| Sony | CCDF40 | UNIT POWERS UP BUT DOES NOT ACCEPT ANY COMMANDS | The unit powered up ok but did not accept any of thecommands. There was no VTR power signal going to the DC-DC converter.The VCR power signal was present at pin 35 of IC-001, but it was not atcollector of Q-079. Unregulated voltage was missing at the e | ||
| Sony | CCDF40 | NO TELE/WIDE OPERATION | There was no lens movement when the zoom switch was pushedfor wide angle. With the zoom switch pushed to the wide side, therewas not a low at pin 4 of IC-200 of SS-86 board. There was an openingbetween W001 pin 5 (WIDE) and the resistor R-029 on the SS |