| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Mitsubishi | CT2627 | Sound increases - oscillates. | Bad connection on audio plug FF. | ||
| Mitsubishi | CT2627 | NO SOUND OR COLOUR + WON'T GO INTO STBY BUT WILL C | R7N5 OC IN 12v REG FEED MAY BE REMOTE IC SC ( SAA1030 ) I THINK !! | ||
| Mitsubishi | CT2627 | No sound | 12V supply to IC 301 missing caused by C305 330uF 25V s.c. In SIF section. | ||
| Mitsubishi | CT2627 | Frame -height varies & int frame collapse. | C412 , C413. | ||
| Mitsubishi | CT2607 | Field collapse | o/c wire on scan coil loading coils | ||
| Mitsubishi | CT25MSTX E14 chassis | Dead - st/by led lights briefly at sw on | dry joints on IC951. Drys were also found on regulators IC952, IC954 & IC955. | ||
| Mitsubishi | CT25M5BT EE4 | Green LED only - prev int off - HT present | No line dr from IC201, no micro activity, replace EEPROM 24C08 & set up | ||
| Mitsubishi | CT25M5BT EE4 | Field collapse | TEA2031A (IC551) & supply decoupler R516 0R82 safety resistor. | ||
| Mitsubishi | CT25M5BT | Sound, no raster | Replace Q6E7 (JC501-R) on the tube base panel (part of the spot-killer circuit). It had a B-E leak and was failing to turn on Q6E8 (2SA950-Y) which in turn robbed the 12 volt feed to pin 2 of the CRT driver chip IC660 (TEA5101B). | ||
| Mitsubishi | CT25M5BT | Sound int mutes | IC701 micro ST9291N6 | ||
| Mitsubishi | CT25M5BT | E/W DISTORTION, LACK OF HEIGHT | REPLACE EEPROM IC | ||
| Mitsubishi | CT25M5B | Under very poor signal conditions "Herringbone" pa | Fit specially screened RF lead between VCR & TV PtNo H24P001010 | ||
| Mitsubishi | CT25M5B | Failure of Q552 | Order & fit AVM5KIT | ||
| Mitsubishi | CT25M3TX Euro 14 | Tuning instructions | Select chan & press preset on r/c (tuning display appears in blue at bottom of display), change to yellow by pressing up/down chan. press vol +/- to start search tune, then press vol + until channel is displayed, press preset button to store | ||
| Mitsubishi | CT25M3TX Euro 14 | Difficult to come on from st/by, wont stop at stations & graphics wrong | C955 2200µ 25v leaked over EEPROM IC702 X24CO4P - both need replacing |