| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | CFD600 | UNIT DISPLAYS NO DISC - CHECK SOLDER SHORT ON C819 | Unit displays no disc when disc inserted. Mechanism wil notgo anywhere. | ||
| Sony | CFD600 | MECHANICAL NOISE WHEN TAPE IS IN UNIT AND PLAYING. | Unit produces rubbing or squeak noise when playing a tape. | ||
| Sony | CFD600 | DISC JAMMING | Disc may become trapped in the disc case after improperloading. | ||
| Sony | CFD600 | NO PICKUP/INT PICKUP | Optic wires too short and could cause many cd failures inthis unit. Boombox team evaluated 5 units that failed during burn test, 3of 5 failed due to white optic wire connector being slightly pulled out. -SOLUTION :Replace optic wire set with 1 slightly | ||
| Sony | CFD560 | PART NUMBER FOR IC703 | The unit has a different type of IC, IC703 - KS9211 andservice manual listed as CXD1167Q. There is not part number in Sonyreplacement book. Need part number for KS9211Tel 810-344-4354 FAX 810-344-4899 -HQ COMMENTS: Contact Knsas City Parts, attn Jam | ||
| Sony | CFD560 | DISTORTED AUDIO AND THEN SHUT DOWN OF CD | After unit warmed up CD audio would distort and then unitwould eventually shut down. Freezing IC white it was distorted wouldclear up the problem and heating IC would cause problem to reoccur. -HQ COMMENTS: Replaced IC701. | ||
| Sony | CFD560 | NO AUDIO RIGHT SIDE - REPLACE C124 (1-126-176-11) | No audio on right side. Good audio on left but not audible. | ||
| Sony | CFD550 | INTERMITTENT TOC OR PLAY | Cables from the laser assy to CD main board are intermittentcausing intermittent TOC or play. The part numbers for the cables are notin the service manual. I requested a parts research from KCP, theyresponded that the aprt numbers for these cables are | ||
| Sony | CFD550 | PART NUMBER FOR CABLE | Part number for cable between CNP701/CNP702 and optical blockmissing in service manual. Need part number Tel 810-344-4354 FAX 810-344-4899 -HQ COMMENTS: I suggest you contact KCP. It may be that the cable | ||
| Sony | CFD550 | SPEAKER DISTORTION/BUZZ | Speaker terminal is bent upward causing distortion/buzz inspeaker. | ||
| Sony | CFD540 | TEST MODE | CD will not go into test mode by shorting TP CD Test.Shorting 3.67vdc to ground prevents power switch S813 from turning on. | ||
| Sony | CFD520 | TEST MODE | CD will not go into test mode by shorting TP CD Test.Shorting 3.67vdc to ground prevents power switch S813 from turning on. | ||
| Sony | CFD510 | UNIT DEAD - REPLACE FUSE | Unit dead, shield covering CDB not soldered to board andshorts out Q305 and blows fuse. This is third unit with same problem | ||
| Sony | CFD30 | IC201 KEEPS GOING OUT | Unit came in with IC201 out. Servicer replaced andreturned to customer. Customer returned unit with IC out again. Servicerreplaced again and it played for three hours and went out again. Whenoperating all voltages on IC are normal and there is no r | ||
| Sony | CFD250 | OPTICAL BLOCK REPLACEMENT | When replacing optical block for this model the 884824601listed in manual is shipped. This part will not connect to thetranslation board item 651. I have found after research that SB 332 whichis for the CFD580/757/758/767/768 lists the translation boar |