| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | TAM30 | WRONG PART NUMBER IN SERVICE MANUAL | Part number (page 21, reference No. PH-2) 8-719-710-34 isincorrect. | ||
| Sony | CCDF55 | REEL GRINDING DURING THREADING | Capstan motor high speed when set to play made a reel grindingnoise during threading. | ||
| Sony | CCDF56 | REEL GRINDING DURING THREADING | Capstan motor high speed when set to play made a reel grindingnoise during threading. | ||
| Sony | GV9 | PICTURE HAS A GREEN DOT | Picture has green dot in the center of screen about one inchup from the bottom. | ||
| Sony | SLV555UC | STILL NO REWIND WHEN PHOTO SENSOR KIT IS INSTALLED | After kit was installed, found high speed Rewind is too slowand normal Rewind to shut down. | ||
| Sony | KPR4110 | HORIZONTAL BLACK LINE 1/2 UP FROM BOTTOM OF SCREEN, C-5079 | Unit displayed a black line resembling a pencil score markhalfway up from the bottom of the screen going horizontal across thescreen. This line was no more than 1/16 of an inch in diameter. Linedissipated after first five minutes of operation. | ||
| Sony | SLV555UC | UNIT SHUTS DOWN | Unit shuts down from low amplitude drum FG. Waveform shape iscorrect but the peak-to-peak level is only 1.5 volts. | ||
| Sony | MDP510 | DOES NOT PLAY ON CD BUT PLAYS FINE ON LD | Plays fine for LD and CDV but when CD is inserted the FOPkeeps moving inside making mechanical noises. | ||
| Sony | D180K | FLASHING LIGHTS - NO OPERATION | X-601 was oscillating erratically causing erratic operation ofIC-504 PWM Driver. | ||
| Sony | ITA850 | NO MEMO RECORD | When MEMO/REC is pressed, the OGM will fast forward to the endof the tape and an error beep will sound. | ||
| Sony | CCDF33 | NO VIDEO | No output video. | ||
| Sony | CCDTR4 | IRIS INTERMITTENTLY OPENS/CLOSES | Iris intermittently opens/closes. | ||
| Sony | CCDF55 | NO VIDEO FROM CAMERA | No video from camera. | ||
| Sony | KV32XBR70 | DEAD, REPLACE Q-505, Q-503 AND R-571 | The PCB and the pictorial have the legs of Q-505 mislabeled.I believe reverse the base and emitter for proper installation. Even whenQ-505 is on heat sink, it can be reversed. On this set, Q-505 was shortedalong with Q-503 and R-571. Replacement did n | ||
| Sony | KPR46CX10 | VERTICAL SWEEP COLLAPSE, REPLACED Q-403, 404, AND 405 | Failure caused CRT Permanent damage (Red CRT). |