| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV32XBR10 | ONLY 27 OUT OF 32 CHANNEL CAPTION MEMORY AVAIL., SEE BELOW | Operating instructions (pg. 40, attached) say up to 32channels may be labeled. I can only get a maximum of 27. When one isdeleted, making 26, another cannot be added in its place. The amount ofcharacters (1-4) stored per station seems to have no affec | ||
| Sony | WMF2031 | SCANS VERY SLOWLY - NO RECEPTION - INTERMITTENT | No reception, scan function very slow. If cassette lid isflexed, all functions return to normal, intermittantly. Seventh occurenceof this problem. L-802 is soldered directly to C-819, causing L-802 tocrack when lid is flexed. | ||
| Sony | HVM302 | BNC ADAPTOR FOR THE HVM-302 | There is an adaptor for the HVM-302 which breaks out the fourpin connector into a BNC connector for video and a power supplyconnection. Do you know how I can get one of these for service? -HQ COMMENTS: The model number of the adaptor you mentioned is H | ||
| Sony | KV27FX10 | INTERMITTENT VERTICAL PICTURE DISTORTION | Intermittently, the unit would have a distorted picture.This distortion appeared on the top 25% and lower 5% of the picture area.It looked as if the top 25% of the picture would be stretched for a periodof time then, it would return to normal. The stran | ||
| Sony | KV2680R | IC-601 NO REGULATION, REPLACE C-540 ON 135V LINE | Found IC-601 power regulator would not regulate. | ||
| Sony | KX1901 | PICTURE SHRINKAGE | Picture shrinks about 1/4 inch - 1/2 inch at the top of thescreen. | ||
| Sony | KV2645R | PICTURE SHRINKAGE, REPLACED R520 | Picture shrinks about 1/4 inch - 1/2 inch at the top of thescreen. | ||
| Sony | RME300 | PART NUMBER FOR THE CONTROL "L" CABLE 3 PIN TO 3 PIN | What is the part number for the three pin to three pin controlL cable in the RME-300? | ||
| Sony | CDP670 | ABNORMAL TRACKING | When trying to advance to the last track of the YEDs 18 disc(track 22), the laser would advance to the outer edge, the disc would stopspinning, the laser would go back to the limit switch and then advance totrack 22 and play. | ||
| Sony | CCDF55 | TECH TIP FOR SERVICING WITH MODE SELECTOR III | When working on CCD-F55s, there is no way to hook up the load-ing motor to the mode selector. Technical Department is researching aboutgetting a connector which could hook two cables to the mode selector. | ||
| Sony | CFSW30 | INCORRECT PART NUMBER FOR SPRING - REFERENCE NO. 12 | The part number for reference No. 12 of exploded view on page21 of service manual is incorrect. | ||
| Sony | CFSD30 | WRONG PART NUMBER LISTED IN S/M FOR VR-101 | This part is the bank of slide pots for the EQ and the Volume.When this part is ordered, the part received is a 2-gang rotary pot. Thepart received is the balance control for a TC-WR510. Please providecorrect P/N. -HQ COMMENTS: Tokyo Fax A910094: P/N | ||
| Sony | SLHF750 | UNIT DOES NOT THREAD/UNTHREAD TAPE | Unit would not thread/unthread tape by supplying external DCvoltage to threading motor. Relay gear assembly would slip and chatter.Noticed that the shaft on which this gear assembly mounts on was pushedupwards and didn't enter the hole designated for it | ||
| Sony | SLV272UC | DEAD | Power light comes on for approximately 15 seconds then shutsdown. No switched 12V and 13 volts from pins 7 and 9 of IC-501 regulator. | ||
| Sony | SCD1020S | NO AUDIO ALARM/BUZZER FROM KEYBOARD- NO BEEPS | Audio buzzer not functioning from keyboard - no beeps. |