| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | XTV5 | WHAT IS REPLACEMENT REMOTE FOR THIS UNIT | Customer is looking for a remote for his XTV-5 tuner. Theunit came with a RM-X5 but this came up no longer available. Can you tellme which remote will work as a replacement? -HQ COMMENTS: This remote was a very simple remote. It just had Ch,vol, pix, | ||
| Sony | PVM1910 | CANNOT ADJUST H SIZE | H size is too wide. I cannot adjust H size. DC voltage dis-appears on Q-801 collector. | ||
| Sony | KV25DXR | DAMAGED c-570 ON (D) BOARD (JAIL BAR - ON LEFT SIDE SCREEN | Jail bar appears on the left side of screen. | ||
| Sony | KV2073R | TUNER DRIFT | Tuner drift (very intermittent). On some cable systems Ibelieve our tuners are being confused by the sheer amount of signals andthe + and - mixing products are causing our tuner/synthesizers to drift toadjacent channels. | ||
| Sony | KV27DS1 | TUNER DRIFT, TROUBLESHOOTING SUGGESTION | Tuner drift (very intermittent). On some cable systems Ibelieve our tuners are being confused by the sheer amount of signals andthe + and - mixing products are causing our tuner/synthesizers to drift toadjacent channels. | ||
| Sony | SLHF1000 | NO OPERATION (DEAD) | The 9V and 12V from IC-002 were missing. Found C-024 (47uf)at pin 15 shorted. | ||
| Sony | SL2710 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2700 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2500 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | SL2400 | DRUM MOTOR NOT RUNNING | Conductive glue on hall device. As it got older and harder,it was not allowing the hall device to conduct. | ||
| Sony | KV2649RX | ANTENNA CHANGE SWITCH | This part is no longer available. What do we use as asubstitute for this part?-HQ COMMENTS: Please see service bulletin number 61. | ||
| Sony | FD500 | PART NUMBER FOR CHARCOAL GRAY KNOBS MISSING | There are no part numbers listed in the service manual for thecharcoal gray knobs. | ||
| Sony | KV1953R | D-510 LEAD WAS TOO SHORT | D-510 lead was too short. Not through PC board. | ||
| Sony | SLHF450 | NO BETA HI-FI | No Beta Hi-Fi or Beta Hi-Fi light. Regular audio is ok. Wehave three reports of this. | ||
| Sony | PBR330 | PART NUMBER NEEDED | I need the part number for the microphone holder that goeswith a PBR330 parabolic reflector. -HQ COMMENTS: The following part numbers must be ordered: 2-212-424-00,2-212-425-00 and 2-212-426-00. Please note that since this is not a U.S.product there wi |