| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Mitsubishi | Euro 12 | Excess width | TEA2031A | ||
| Mitsubishi | Euro 12 | Dies at sw on with squealing | C956 1000µ 35v, C958 1000µ 16v, C964 1000µ 50v leaky & dry joints & IC551 (e/w chip) & TEA2031A damaged | ||
| Mitsubishi | Euro 12 | Dead or Int reverts to st/by - LOPTr Q522 fails periodically - possibly due to high HT | C906 47µ 50v drive coupling cap - also check C905 470µ 35v, C909 100µ 25v,C920 100µ 25v, R961 150k, R972, R960, D907 RD3.0 s/c & IC950; Q522 = 2SD1877 (21"), 2SD1878 (25"), 2SD1879 (29") | ||
| Mitsubishi | Euro 12 | Dead apart from 3 chirps at sw on | LOPTr 2SD1878 s/c also replaced C956 47µ in psu | ||
| Mitsubishi | Euro 12 | Dead - off with bang | C906 47µ 63v, Q901 2SD1887, R901 4R7 10w, IC901 TEA2261, D907/8 RD3.0FB1, C920 100µ 63v - C975 47µ 63v was the cause | ||
| Mitsubishi | Euro 12 | Dead - LOPTr s/c due to High HT | Check R961 150k & C906 47µ 50v & IC950 | ||
| Mitsubishi | Euro 12 | Dead - Chopper Q901 & lop tr Q552 u/s | Q901 serv kit fitted & Q552 2SD1878 also C905 470µ 35v, C906 47µ 50v, C909 2µ2 50v, C920 100µ 25v | ||
| Mitsubishi | Euro 12 | Dead - blows Q901 | C906 47µ 50v | ||
| Mitsubishi | Euro 12 | Dead | Q552 2SD1878 s/c; R901 4R7 10w o/c | ||
| Mitsubishi | Euro 12 | Contrast low with fb lines | IC251 pin 7 only 1.2v instead of 2.9v; 12v line low as Q704 leaky | ||
| Mitsubishi | Euro 12 | Blue excessive (or Green/Red) | D656 leaky on crt base ( or D655, D657) | ||
| Mitsubishi | Euro 12 | Black box appears on screen &/or no TXT | C958 1000µ 16v in 5v supply | ||
| Mitsubishi | Euro 11 CT25B3 | Int comes on with small pic - other times ok | HT was low at 105v (145v) - check/change caps in psu sec | ||
| Mitsubishi | Euro 10 CT21M1TX | Sideways wobble to pic | C905 470µ & C906 47µ in psu pri | ||
| Mitsubishi | Euro 10 | Switches off immediately after powering up | Check PC951 opto coupler |