| Marca | Modelo (Chassis) | Sintoma | Causa | Solução | Por: |
|---|---|---|---|---|---|
| Sony | KV27TS32 | NO PICTURE, REPLACED TUNER | Unit had no picture screen would light up with antennaconnected. Has green spot in upper right hand corner. Gray diagonallines moving up screen. Traced problem to defective tuner. | ||
| Sony | KV27TS27 | INTERMITTENT VERT ROLL, REPLACED C329 | OCCASIONALLY THE PIX WOULD ROLL UPWARD. WHEN COLD UNIT OK. ONCABLE WOULD ROLL MOST OF TIME. ON OFF AIR PIX SEEMED STABLE BUT WOULDOCCASIONALLY FLIP. IT SEEMED DEPENDENT ON SIGNAL STRENGTH, AND DARK SCENESOF PIX WOULD CAUSE SYMPT.SOLUTION: PLUG IN MODULES | ||
| Sony | KV27HSR10 | NO PART NUMBER LISTED, RD18ESB1, 8-719-110-48, D-251,252 ETC | As per Supplement No. 1, the diodes D-251, 252, 253, D-310,and D-311 are listed as RD18EST1B1. No part number is listed, nor is thistype name in the Replacement Book. -HQ COMMENTS: According to Japan, the diode type name is:RD18ESB1 part number 8-719-1 | ||
| Sony | KV27HSR10 | NO SYNC OR COLOR, REPLACED C338 | No sync or color trace video signal to C338. | ||
| Sony | KV13TR28 | TV SHUTS OFF BY ITSELF, REPLACED FBT | TV on one second then shuts off. | ||
| Sony | KV13TR28 | INTERMITTENT PIX, SOLDER SPLASH ON TUNER | Unit displayed various symptoms, blanked no pix, no vertsweep horiz line across screen, full raster snow no tuning. Tappingtuner w/screwdriver would cause sympt. R681 overheating, tuner 5 voltssometimes missing. | ||
| Sony | KV1397R | NO AUDIO, SEE SERVICE BULLETIN 291R2 | This unit had no audio. The collector resistor for Q252 wasopen although it does not show a resistor number in the schematic. It ismarked R255 on the board. | ||
| Sony | KP61XBR28 | ANODE LEAD ASSEMBLY, NOT SOLD SEPARTELY | Service Manual lists the Anode lead Ref 128 as P/N1-559-865-41. It is not available. -HQ COMMENTS: This lead comes with the CRT. It was mistakenlylisted in the part list. It is not available as a separate part. This was covered in Correcti | ||
| Sony | KP53XBR25 | ANODE LEAD ASSEMBLY, NOT SOLD SEPARTELY | Service Manual lists the Anode lead Ref 128 as P/N1-559-865-41. It is not available. -HQ COMMENTS: This lead comes with the CRT. It was mistakenlylisted in the part list. It is not available as a separate part. This was covered in Correcti | ||
| Sony | KP46XBR35 | DEAD SET, REPLACED IC1704 AND HOLDING CLIP | Set came in dead. While troubleshooting the unit, it wasnoticed that the clips holding IC1704 were missing, and the IC wasnot touching the heat sink. The IC was found to be shorted. | ||
| Sony | KP46XBR25 | ANODE LEAD ASSEMBLY, NOT SOLD SEPARTELY | Service Manual lists the Anode lead Ref 128 as P/N1-559-865-41. It is not available. -HQ COMMENTS: This lead comes with the CRT. It was mistakenlylisted in the part list. It is not available as a separate part. This was covered in Correcti | ||
| Sony | FDL-K400 | RUBBER ADDED TO STAND, SEE CORRECTION 1 | Rubber piece added to stand. Please refer to Service Manual Correction 1. Part number for rubber piece 4-033-485-01 | ||
| Sony | ITD20 | PART # OF 4 PIN LINE JACK BASE 1-580-143-11 | Ordered 4 pin line jack from KC. Got mistagged 4 pinhandset cord jack instead. Tried reordering with same result. Handsetjack arrives with the part # of the base line jack on its tag. When Iorder the handset jack under its own real part 157300711, I | ||
| Sony | ITA850 | PN FOR SWITCHES S10 AND S11 ON IC BOARD | Currently, switches are not available except as part of the ICboard.-HQ COMMENTS: Unfortunately these switches are not available separately asthe IC board has a relatively small number of components. | ||
| Sony | ITA750 | PN FOR SWITCHES S10 AND S11 ON IC BOARD | Currently, switches are not available except as part of the ICboard.-HQ COMMENTS: Unfortunately these switches are not available separately asthe IC board has a relatively small number of components. |